Release Notes
SNE2040G-S and SNE2040G-P
4-Port SHDSL Network Extender
Firmware Version 6.00.00
October 6, 2004
New Features and Enhancements
IP Address. The SNE2040 can be configured with an IP address.
ICMP is supported. The SNE2040 is now pingable.
SNMP support. MIBII and Paradyne MIBs are supported.
Authentication, Cold start, and Port Change traps are supported.
Flash upgrades are supported with a Windows utility or TFTP.
Remote reset of the SNE2040-S is supported from a supporting DSLAM SDSL port.
Enhanced performance of BERT testing to allow testing beyond 60 seconds.
Known Restrictions and Limitations
The mumCfgInbandMGMTVlanID OID only supports values 1-255, contrary to what the MIB description indicates.
The IP Address (optional) needs to be put into the SNE2040 using a small Windows command-line based utility that can be found at http://www.paradyne.com/tech_support/tools.html.
Older versions of firmware cannot be upgraded without changing the prom first. Procedures to do this are located at http://www.paradyne.com/technical_manuals/SNE2-A2-GK40-00.pdf.
Paradyne MIBs version 1.01.01 is needed in order to manage the SNE2040 units. The MIBs can be found at http://www.paradyne.com/tech_support/mibs.html.
Compatibility Issues
Running the SNE2040 Windows Utility requires the use of Windows 2000 and Windows XP. Win98 and earlier operating systems are not supported.
It is recommended that all programs including firewalls are turned off when using the SNE2040 utility on your PC.
Release History
240-0000048 rev05
Zhone's Single Line Multi-Service architecture (SLMS™), allows carriers to concurrently deliver voice, new premium data and video services over copper or fiber access lines.
|
