Software Increment Release Notes ================================ Increment ID: ACN04N16 Date created: October 8, 1999 CSR number: 50136767 Title: Fix stuck protection oscillation alarm Detailed Description of Increment: ---------------------------------- The protection oscillation condition is caused by an uninitialized variable. This patch is a propagation of the original fix of thien.39. System Configuration / Shelf Type Requirements: ----------------------------------------------- This increment is applicable only in the AccessNode VTBM ring configuration. Increments Needed: ------------------ ACN00N16 ******** PLEASE NOTE ******* If you have FA processors (32 meg) you must have ACN07N16 applied before applying ACN01N16. If you currently do not have FA processors in the system, and will not be adding any, then you do not need to apply ACN07N16 ACN07N16 **************************** ACN01N16 ACN02N16 ACN03N16 ACN04N16 Loads Affected: --------------- APU: ACCL16DI, ACCD16DI, ACCV16DI, ATBL16DI Installation Instructions: -------------------------- Download increment from the Web. Either a) download the increment directly to the /iswd directory on the OPC. b) download the increment to tape and insert into the OPC tape drive. Start up Incremental SW Del. from the Software Admin toolset on the OPC. Deliver the increment. Apply the increment. Test Instructions: ------------------ 1. Apply increment ACN04N16 2. perform protection switch from OC12 G1 to OC12 G2 3. perform protection switch from OC12 G2 to OC12 G1 4. Ensure the "Protection Oscillation Control Activated" alarms have cleared Display: -------- INCREMENT ID - ACN04N16 TITLE: DESCRIPTION: NE# STATUS NE# STATUS _____ _____________________ _____ _____________________ 49 DELIVERED 50 DELIVERED Apply: ------ **************************** * Summary Of Apply Command * **************************** The command was not aborted. The processors involved: APU Results for NE 49 Increment ID: ACN04N16 Processor Status ----------------------------------------- APU Success **************************** * Summary Of Apply Command * **************************** The command was not aborted. The processors involved: APU Results for NE 50 Increment ID: ACN04N16 Processor Status ----------------------------------------- APU Success Remove: ------- ***************************** * Summary Of Remove Command * ***************************** The command was not aborted. The processors involved: APU Results for NE 49 Increment ID: ACN04N16 Processor Status ----------------------------------------- APU Success ***************************** * Summary Of Remove Command * ***************************** The command was not aborted. The processors involved: APU Results for NE 50 Increment ID: ACN04N16 Processor Status ----------------------------------------- APU Success