Software Increment Release Notes
================================

Increment ID:   I04A1800
Date created:   JUL 19, 2000
SR number:      10351276

Title:  New ANX OC1 (NTN510CB) and HDSL (NTN510BB) SPs supported. 


Detailed Description of Increment:  
----------------------------------
This fix allow new OC1 (NTN510CB) and HDSL (NTN510BB) SPs to be 
supported by the ANX. This patch must be added to the system before 
inserting any new OC1 (NTN510CB) or HDSL (NTN510BB) SPs to an 
ANX Shelf.

System Configuration / Shelf Type Requirements:
-----------------------------------------------
ANX HDT


Increments Needed:
------------------
I01A1800 - I04A1800


Loads Affected:
---------------
SP, LAIC application firmware

After a successful application, the version of the loads will be as follows:
SP - ANXSPL18AG
LAIC Application - LAICL18AG
LAIC firmware - LAICBL18AG


Installation Instructions:
--------------------------
Download increment from the Web:
Either a) download the increment directly to the /iswd directory on the OPC.
       b) download the increment to tape and insert into the OPC tape drive.
Start up Incremental SW Del. from the Software Admin toolset on the OPC.

Deliver the increment:
  1) Select Deliver an Increment.

  2) Type y to verify your selection.

Verify the increment:
  1) From the ISD main menu, select Display Increments.

  2) Select Display to Screen.

  3) Verify the increment delivered have the correct Title
     and Description.  Also verify that their status is
     "READY TO APPLY".

     NOTE: If the increment is a Linecard only increment, the
     status will be "LOAD DELIVERED". 

  4) Press any key to return to the main menu.

Apply the increment:
  1) From the ISD main menu, select Apply an Increment.

  2) In the list, select the number next to the increment you delivered.

  3) Select on e of these options:
     1) Apply to ALL NEs (to set the increment fully into the system)
     2) Trial on one NE (to test the increment to ensure that it causes
        no problems)

     If you select option 2, a list of NEs in the span of control appears.
     From the list of NEs, select the number next to the one you want to
     test.  A confirmation screen appears.

  4) Type y to verify your selection.

  5) When the application is complete, press any key to scroll through
     the Summary screesn until you return to the main menu.
 
  6) From the main menu, select Display Increments.

  7) Select Display to Screen.

  8) Verify that the status next to each NE now reads "APPLIED"
     (or "TRIAL APPLIED" if you chose to run a test in step 3 above).

IF THE INCREMENT INVOLVES THE APU YOU MUST DO THE FOLLOWING STEP
Dump the image:
  1) From the ISD main menu, select Dump an APU Image.

  2) Select one of the valid load types that can be dumped.

  3) Select one of the valid NEs matching your previous parameters.

  4) Type y to verify your selection.

  5) When the image is complete, press any key to return to the main menu.


Test Instructions:
------------------