Software Increment Release Notes
================================
Increment ID:   I15A1905
Release:        AN1905
Date created:   7-10-2004
Increment Type: APU
Title: LC Over-current, LCLOADCI, Call Reject, UE9K loading robustness.
----------------------------------------------------------------------
Following is a list of issues addressed in this Increment. See below
for more details.
1. Line cards stuck in over-current protection state.
2. LCLOADCI command increment fixes.
3. MVI incoming call rejections.
4. UE9K loading robustness.
----------------------------------------------------------------------
1. Line cards stuck in over-current protection state.
* Description: Lightning voltage or other abnormal voltage surges 
can cause certain types of circuits to go into an over-current state. 
These circuits may not automatically recover from this state and need 
to be manually recovered. These pack types include all vintages of
the NT4K65 CDS Epsilon, NTN502 ANX Epsilon II, UE9000 NTNP40 POTS-24,
and NTNP42 UVG-24 line cards.
* Pre-Increment Impact and work-around: The circuit is unavailable
for call processing until it is manually reset at the craft level
of the AccessNode Human Machine Interface (HMI).
----------------------------------------------------------------------
2. LCLOADCI command increment fixes.
* Description: The LCLOADCI command increment tool set default 
diagnostic and load ID commands may not work for all lines when 
setting multiple MLC circuits.
* Pre-Increment Impact and work-around: Using the LCLOADCI
commands to change the diagnostic or load IDs for many MLC 
circuits at once may yield unreliable results. The command 
works when setting IDs on a single line at a time.
----------------------------------------------------------------------
3. MVI incoming call rejections
* Description: If a MVI subscriber goes on-hook between 1.1 and 
1.3 seconds before an incoming call is received, there is a chance 
that the incoming call would be rejected.
* Pre-Increment Impact and work-around: When this occurs, the MVI 
subscriber is not aware of the incoming call rejection and the 
originator gets call failure treatment. Subsequent call attempts 
to the MVI subscriber are successful.
----------------------------------------------------------------------
4. UE9K loading robustness.
* Description: When loading the UE9K shelf during increment application
or new TDM card installation, the ABM shelf could fail to complete 
the load indicating a "Load not Found" condition. This event is more
often seen when the ABM is attempting to load multiple UE9K shelves
at one time.
* Pre-Increment Impact and work-around: Should the UE9K fail to load,
re-attempting the operation would normally succeed. 
----------------------------------------------------------------------
Increments Needed:
----------------------------------------------------------------------
Increment I01A1905 through I14A1905 needs to be successfully applied 
prior to application of this increment.
----------------------------------------------------------------------
Loads Affected:
----------------------------------------------------------------------
APU: ACCL19HI 
APU: ATBL19HI 
----------------------------------------------------------------------
Special Instructions:
----------------------------------------------------------------------
None.
----------------------------------------------------------------------
Installation Instructions:
----------------------------------------------------------------------
Please refer to the Incremental Software Delivery Users Guide for
general installation instructions. This document may be obtained from
either the AccessWeb ISD web site located on the Zhone web page at
(http://www.zhone.com/support/patches/index.html), or you may request
document 830-00374-01 from your Zhone Technologies Account Manager or
Order Manager. Issues with this increment should be directed to
Zhone Global Services and Support at 1-877-ZHONE-20 (1-877-946-6320).