LANA MIB Installation (8/8/96)
---------------------

1- Get a copy of "SNMP LAN Adapter Installation Guide"

2- Load lana.mib into mib browser

3- In order to communicate with the lan adapter, it must
   be connected to a device that has an IP address.  SNMP
   Gets/Sets can then be sent to the lan adapter using
   that IP address. Use the lan adapters MAC address
   (all lower case with ":" separators) for the community string.

4- If you want access to this device from another subnet,
   then set lanaSubnetMask and lanaDefGatewayIpAddr (p. 36, 44)

5- If multiple devices are on a lan adapter, then add
   their IP addresses (other than the primary) to 
   lanaIPAddr (p. 46)

6- After any changes, lanaReset must be set.